5/31/2011

Single X10 POWERMID TRANSMITTER Review

Single X10 POWERMID TRANSMITTER
Average Reviews:

(More customer reviews)
I have 3 transmitters and one receiver. Here's how I set it up: plug in receiver and point it at the AVR. Test to make sure it pointed correctly and it was on the first try. Then I placed the transmitters in their respective zones. Point the remote at a transmitter and it works. It couldn't have been easier.

Click Here to see more reviews about: Single X10 POWERMID TRANSMITTER

If you have speakers or TVs in a separate room from your stereo/VCR/cable box, you know how inconvenient it is to adjust the volume, change DSS channels, radio stations, etc. Infrared (IR) remotes do not work through walls. You have to walk into the other room any time you want to make a change. With the PowermidTM you can now control your equipment through walls up to 100 ft. away.Point your remote at the PowermidTM Transmitter, it converts the IR signal into a radio frequency (RF) signal that can pass through walls. In the room where your audio/video equipment is located, the receiver converts the RF signal back into IR and transmits it to your equipment.The transmitter even blinks a red light to indicate that it is receiving your command.You'll need this item if you need to control equipment from more than one room. (Receiver sold seperately.)

Buy NowGet 50% OFF

Click here for more information about Single X10 POWERMID TRANSMITTER

No comments:

Post a Comment